muskaan's T*I*P*S: Claudia Huber

Showing posts with label Claudia Huber. Show all posts

Tuesday, 27 December 2016

a free pattern fluttering in

October to December – a long journey for this little butterfly pattern !

Remember the sneak peek of this joint project on Craftree? Claudia was asked by someone to locate or correct a tatted butterfly pattern. It had been tatted ages back and the original pattern was lost. When we couldn’t find the designer online, Claudia did the stitch count & I diagrammed and christened it. Finally, the pattern is shared here.

Together We Fly Butterfly

a joint project on Craftree

designer – unknown ; stitch count – Claudia Huber

diagram & pdf - muskaan

pattern pdf here

If tatting with single shuttle and ball, pull out a 12-15 inch long tail from the shuttle before starting head. This tail will be used to complete the 2nd half of split ring which constitutes the body.

This is how the butterfly can be tatted in one pass, using split ring and mock picot to climb out.

Claudia’s TIP shared here : “The butterfly had to be made wet and putting in the final form as the body should be oval, and not round, but it laid flat already before, now it looks nice, without fixing and blocking etc.”

I like the slightly oval look. Also, I found it easier to pull the ring After starting the chain, so as not to hamper the ring closure.

The butterfly can be worked in opposite direction to that notated in diagram (see below), as seen in this 2-colour version using single shuttle and ball. In this case, the split ring body will be worked as:

SR-B : 4 – 3 – 4 long picot 4 / 4 – 3. Mock Picot to climb out for wing.

Also, in above model, I made the 2 rings, then joined the solid purple thread for chains, tatting over tails. Unfortunately, the variegated thread soon broke and this model was discarded.

After completing Wing #1, we need to cross over across the neck, to continue with Wing #2. This can be accomplished using an over-under or alligator join. On trying it, I did not like the horizontal bar it makes.

I opted for 2 lock joins in same picot, but on either side. It stabilized the head as well.

TIP : If desired, the 2 stitch chain on either side (seen in blue in diagram above) can be increased to 3 double stitches. With only 2 stitches, the head is nestled too close and the wings have to be pulled outwards to finish.

The single colour version, using 2 shuttles, CTM

I tatted a new model, this time using 3 colours. Head & body are tatted in brown (4054-0359) and tails hidden. Then I joined the maroon (4054-00022) and golden yellow (4054-0307) for the wings.