locked in play

Continuing from my previous post where 2 methods of Interlocking split rings (chain maille style) were uploaded. Again, I follow Ninetta's post to share the 3rd method based on Kathy Niklewicz's method and then its further application in the tatted rope chain.

I first tried Kathy's single-shuttle IR method (along with other methods) in 2014 here. Ninetta took it a step further by using it to create a truly 3D effect. This variation is photographed stepwise below.

C. Interlocking Split Rings - Chain Maille

ref : Kathy Niklewicz's Interlocking Rings and Ninetta's Method 3 variation

Red is shuttle 1 with cream thread ; yellow is shuttle 2 with variegated thread.

All split rings are 8/8.

 

C-1 : Unlike the earlier methods (refer previous post), in this case we can safely close the split ring. 

C-2 : Through the closed ring, insert a hook from the back and hook it to shuttle1 thread.

 

C-3 : Pull a loop front to back through the ring, as seen.

C-4 : Pull out enough of the loop and note the position of each thread(s). 

 

C-5 : Wrap the loop around your hand just as in the earlier methods. The static end of loop is is to the left (where stitches will start) and the moving shuttle part goes around, emerging toward the right.

C-6 : Leave some bare thread (indicated by hook) and start tatting the stitches for 1st side of SR.

 

C-7 : Wrap loop around hand for 2nd side of SR; leave some bare thread (notice the yellow segment) and begin unflipped stitches. Note that the 2nd shuttle thread is within the loop.

C-8 : Stitches complete on both sides.

 

C-9 : Close split ring. 

C-10 : Repeat steps to make as many interlocked split rings as desired.

The advantage of this method is that one does not have to remember to insert the shuttle before closing ring. The disadvantage is that bare thread can be visible from some angles.

A very small variation of this method is used to create the rope chain.

Jane McLellan has used the same method to create a chain maille with a single shuttle and regular rings.

Ruth Perry probably pioneered the modern technique and has created beautiful effects using only chains or 4 shuttles where the bare thread can be eliminated. Teri Dusenbury has instructions for the same using 2 steps and finger tatting here.

This method of pulling a loop through a previous element to tat a ring has also been demonstrated by Patty Dowden to make wonderful rings on picots. 

And don't miss this recent video by Edda Guastella who creates a variation of the chain maille using single shuttle.

Unfortunately, this series will run into a 3rd post dealing with the rope chain, to avoid an avalanche of pics. Instead let me show you my very first chain maille trials.

Above are my Day 1 trials, in Anchor size 20 threads. On the left sampler are my trials of the 3 methods and variations. 

Can you spot the rings that do not look interlocked? Although I do not fully understand why that happened, I think the following TIP might help avoid such mistakes, because there is a tendency for the loop to get stuck at the base of the previous ring -

TIP : 1. After completing 1st side, tug at the core thread that is on the lower right (where you would start the 2nd side stitches). You will notice that the 1st side moves towards the right under the previous ring. 

2. In the 2nd image, the 1st stitch of 1st side, is visible on the right. So you are now sure that your ring is interlocked correctly, and can continue to tat the 2nd side.

3. Tat the 2nd side of split ring and continue with the chain maille method you are using.

Part 3 will be the final post for the present. Of course there will be more projects in the future when I try out the several methods and effects listed above.