double trouble motif

So, here’s what I did with the treble arches (from previous post) to showcase their gracefulness! And despite the title of this post, I found it very relaxing and enjoyable ;-D Perhaps you would like to give it a go as a practice piece?

I started with the same first round rosette as in the snowflake since I wanted to check on something. It can be made smaller, of course, and the next rounds adjusted accordingly.

Treble  Arches  Flower  Motif pattern

muskaan © May 2020

Abbreviations : ctm = continuous thread method ; SCMR = self-closing mock ring ; 

rw = reverse work ; tds = treble tat stitch

NOTATION for Graduated or Variable Treble Tat Stitch (tds)  :

The original tds is made by pulling 2 loops consecutively for 1^st part, and 3 rolls/wraps in 2^nd part. In order to create a relatively smooth gradient, both halves of the tds have been tweaked. A notation that can convey this clearly was needed. I find the following notation (similar to the pds) easiest to indicate the range of variability.

I followed this pictorial and this explanation. Here is Ninetta's summary and links to tds posts.

Following the above logic, a normal tds would be notated as tds(2,3) where 2 loops are pulled and 3 wraps/rolls are made. However, tds is retained in instructions. 

The following tds variations have been used in this pattern :

tds(1,2) = 1 loop pulled, 2 wraps/rolls made.

tds(3,4) = 3 loops pulled, 4 wraps/rolls made.

tds(4,5) = 4 loops pulled, 5 wraps/rolls made.

tds(5,7) = 5 loops pulled, 7 wraps/rolls made.

A single tds is tatted each time, hence, no number is indicated on the left in this pattern.

All rounds are tatted using a single shuttle and ball, without cutting the thread between them (ctm). Shuttles require only short lengths.

Round 1 : Red ball and shuttle, ctm

SCMR: 4 ± 4 ± 8 – 8 – 4 – 4. close. rw

Chain: 1

Repeat this 5 more times, joining to previous ring and last ring to first ring.

I direct-tatted the chain using reverse stitch. See details here.

Round 2 : yellow ball and shuttle, ctm

Note: Each arch starts and ends with 2 double stitches.

Attach thread to 2^nd picot on Round1.

Chain: 2, tds(1,2), tds, tds(3,4), tds(4,5), tds(5,7), tds(4,5), tds(3,4), tds, tds(1,2), 2, lock join. Repeat 5 more times.
One can stop after this round.

Round 3 : mustard yellow ball and shuttle, ctm

Attach thread to free picot on Round1, from the back.

Repeat Round 2 all around.

Possible variations –

• Overlap the arches of 3^rd round with previous round.
• Add more rounds/layers.
• Instead of blocking flat, keep the petals raised in 3D effect – in the right colours one could make a water lily or lotus surrounded by leaves!
• Add beads and findings to convert into earrings or pendant.

Measurements when worked in Anchor size 20 - 

Round 1: <4cms (with picot)

Round 2: >5cms. (3 cms as a hexagon side)

Round 3: 5½ cms (3½ cms as a hexagon side)

So what do you think? Are the instructions and notations clear? If you can suggest an alternate or better notation, please do share. 

happy tatting :-)